Plastic Parts Made for Ferrari and Lamborghini

There were few replacement parts made for Ferrari and other Italian cars because the production numbers were so minimal and any stock was exhausted long ago. Many of the mechanical components for Ferrari’s are common to most models but the body and trim parts are getting hard to find.

I have taken it upon myself to make some parts. Long ago I made Air Conditioning vents, knobs, and little parts for 330GTC/GTS’s and 365′s. Every 330/365 at our shop is missing the alternator junction block cover and knob so I have re-made these parts. Often, the junction block itself is melted from years of engine bay heat and electrical heat so I make the complete units too.

Awhile ago, I made the thumb screws for Lamborghini air cleaner lids with the FIAMM logo.

Now, I am working on making some shift knobs, interior knobs and trying to make the vent window knob for the 330GTC so let me know if you need any of these parts.

If you need a part made, please let me know. Its easier to make a copy from an original part but I can make a part from a mechanical drawing as well. I am learning the techniques to make the molds, hard point holders and account for the shrinkage of the liquid plastic as it sets up.

Here are some of the parts I am making so far.

Plastic Reproduction Ferrari parts

Ferrari replacement parts, Plastic reproduction

Alternator Junction block Ferrari

Ferrari 330GTC Junction block

 

Tweet This!

Leave a Comment