Ferrari Craft » brakes

Old World Wool Seal Making

admin — Wed, 12 Oct 2011 15:08:34 +0000

Wool felt front wheel seal

Today Peter created new bearing seals for the 1934 Lagonda M45 Rapide. The seals of the day did much the same job as today’s plastic over steel equivalent. The main sealing surface is wool felt that, soaked in oil, does a good job holding most of the oil and grease in place. The tools of the trade are pretty simple ones: a spoon, a ball-peen hammer, scissors and a razor blade. The thick wool felt is traced and cut via razor blade.

To make the wool a bit “proud” – to stick out like the chin of a duke – paper gasket material can be cut and built up behind the wool. A spoon and a ball-peen hammer are all that is needed to make an imprint to cut out.

This twenties automotive seal technology was used in agricultural equipment for decades such as wheel seals on an Oliver or Cockshut tractor.

Using the ball-peen hammer to trace the inner lip on the gasket

A spoon has a nice radius for tracing the outer edge of the seal

Lagonda M45 Rapide front brake shoes and axle with hub removed

Cleaning and Ebaying

admin — Wed, 09 Feb 2011 16:08:47 +0000

We cleaned out the attic over the holiday and discovered a number of items that we’ll be putting on eBay in the coming weeks. Currently listed are a Bosch Voltage Regulator (black box BOSCH) 6v 12v volt for returning your classic back to the original configuration – or just the look.

A Ferrari Bonaldi Brake Booster for rebuild will only stop you in your tracks in it’s current condition – not working – but in very nice cosmetic shape.

A rare Ferrari 275 GTB and GTB/4 Egg-Crate Grille Brandoli reproduction isn’t easy to come by and is in good condition.

Marchall 660 Fog Lights for Ferrari 250, 225, 212, 166 will actually look at home on a variety of other cars including Porsche 356, Mercedes 300, etc.

Porsche Speedster 1955

admin — Tue, 01 Feb 2011 14:26:50 +0000

The 1955 Porsche Speedster is in for some work after sitting for 10 or so years, while the brakes worked well enough, we pulled them all apart to inspect the innards and found some corrosion and pitting inside the cylinders. I sent them off to be sleeved and overhauled them with new rubber cups.

Porsche Speedster brake cylinders

Drum brakes Porsche

Reservoir lid for Ferrari

admin — Sat, 02 Jan 2010 15:59:02 +0000

Clean brake fluid is a must for proper operation of a brake system, proper operation of brakes, reliable brakes? Ferraris 250′s with the Bendix/Bonaldi booster had a reservoir cap with a steel mesh under an aluminum disc to allow the bottle to vent. Under the mesh is a small hole directly into the brake fluid reservoir. As you can see, there is lots of opportunity for crud to get into the fluid from this rusty build up in the mesh. I took the aluminum disc off, made a new spacer ring and welded it onto the cap. I sent the part of to be cad plated and made a new aluminum disc, installed stainless steel wool under the and wrinkle finish painted it. Voila!

FIAT Reservoir lid

Wrinkle finish reservoir

Before and after shots of Lusso Suspension

admin — Mon, 21 Dec 2009 15:23:38 +0000

Here is what amounts to about $5000 in labor, the front suspension on a Ferrari 250 completely overhauled and detailed.

New pins and bushings, proper finishes and hopefully it will look this good for more than a few years!

90,000 miles on a Ferrari

Cleaned up, overhauled and detailed